2.1.2. Check of pressure of oil (Z10XE, Z10XEP)

Before holding a procedure of check the engine has to be heated-up (temperature of min. oil of 80 °C).

Procedure of check
Open a cowl.
Remove the oil pressure relay.
Disconnect the socket of a plait of wires.
Substitute the reception pallet.
Install special KM-498-B adaptation.
Check engine oil pressure.
Start the engine.
Pressure of oil of the engine has to be about 150 kPa (1,5 bars) on idling turns.
Stop the engine.
Remove special KM-498-B adaptation.
Install the oil pressure relay upon a head of cylinders and tighten the moment of an inhaling 20 N · m.
Replace a sealing ring. Connect the socket of a plait of wires.
Check and if necessary modify the level of engine oil.
Close a cowl.