Open a cowl

Disconnect plugs of the rechargeable battery

NOTE On cars since a year of release 04 with ESP – after each detachment of the accumulator the sensor of an angle of rotation of a steering wheel loses the main installation. It needs to be calibrated anew.

Disconnect a weight wire.

Disconnect 4 sockets of a plait of wires of a control system of the engine: oil 2 pressure relay, sensor of temperature of cooling liquid 3, sensor of the camshaft 4, module of ignition 1.

Free the canal for a plait of wires 5.

Put a plait of wires aside.

Dismantle the ignition module.

Uncover the ignition module, shift it to the right.

Turn off 2 bolts of fastening.

Take out a cover by means of KM-6009 adaptation.

NOTE Do not warp the provision of a cover.

Uncover a head of cylinders.

Dismantle 2 hoses of ventilation of a case of the engine.

Turn off 13 bolts of fastening of fastening.

Lift the car.

On the ECO model uncover the engine below.

Remove a carving stopper of a support of a bent shaft 1.

Lower the car.

Establish the provision of VMT of ignition of the cylinder 1.

Insert the KM-952 2 device.

Evenly turn a bent shaft until KM-952 adaptation is captured.

NOTE The mark in a belt pulley of a bent shaft 4 has to be on one line with a lug 3 on the GRM case.

Insert the KM-9531 device, it has to enter a groove of camshafts.

NOTE If it is impossible to insert the KM-953 device, then it is necessary to execute the main adjustment of phases of gas distribution.

Install KM-9541 adaptation. Get on a disk of the phase sensor 2.

NOTE KM-954 has to enter a groove of a disk of the phase sensor.

Take out the fixing tools.

NOTE The fixing tools cannot be used for keeping.

Lift the car.

Establish a carving stopper of a support of a bent shaft.

Replace a sealing ring.

Tighten a bolt the moment of 50 N · m.

Lower the car.

On the ECO model establish an engine cover below.

Clean sealing surfaces of a head of cylinders and a cover of a head of cylinders.

Establish a cover of a head of cylinders 1.

Replace consolidation 2 and a sealing ring.

Apply sealant (distance of 1-2 mm).

NOTE Installation works need to be finished within 10 min.

Tighten 13 bolts of fastening the moment of 8 N · m.

Establish 2 hoses of ventilation of a case of the engine.

Install the ignition module.

Turn off 2 KM-6009 devices.

Tighten 2 bolts of fastening with the moment of 8 N · m.

Establish a plait of wires of a control system of the engine.

Lay a plait of wires.

Fix the channel for a plait of wires.

Connect 4 sockets of a plait of wires.

Connect plugs of the rechargeable battery.

Program volatile memory.

Close a cowl.