Dismantle the holder of the socket of a plait of wires 2.

Release and disconnect the socket of a plait of wires of the position switch of the lever of gear shifting 1.

Wring out from a control lever a cable of the drive of gear shifting 3.

Install KM-962-A devices with KM-962-10.

Connect to the socket of a plait of wires of the position switch of the lever of gear shifting.

Connect to the accumulator.

Transfer the gear shifting lever by rotation of a control lever 2 to neutral situation.

NOTE First of all, the lever of gear shifting needs to be turned to the left against the stop (in the direction of the movement), right after it to turn back on 2 lock positions ("P", "R", "N"). For position of the N lever the light-emitting diodes corresponding to marks in the sliding table have to light up.

For adjustment turn off lock screws 1.

NOTE Turn the position switch of the lever of gear shifting so that all light-emitting diodes corresponding to position of the N lever lit up.

Tighten lock screws – 25 N · m.

NOTE Make switching consistently of all transfers by turn of a control lever. For each separate position of the lever of gear shifting the light-emitting diodes corresponding to marks have to light up. If necessary repeat the procedure of adjustment.

Dismantle KM-962-A devices with KM-962-10.

Disconnect from the accumulator.

Disconnect from the socket of a plait of wires of the position switch of the lever of gear shifting.

Install the socket of a plait of wires of the position switch of the lever of gear shifting 1.

Attach and fix the socket of a plait of wires.

Delay fastening of the socket of a plait of wires of 2-20 N · m.

Establish a hummock wire of system of the drive of gear shifting 3 on a control lever of the position switch of the lever of gear shifting.