Remove the top nut 2 from a depreciation rack.

Remove a protective cap 1 from the shock-absorber.

Remove a forward wheel.

Note situation concerning a wheel nave.

Remove a pendulum 3 from a basic pipe of a depreciation rack.

Hold two flat surfaces of a spherical finger of the hinge with an open wrench.

Exempt a plait of wires of the ABS 4 wheel sensor from clips in the depreciation rack directing on a basic pipe.

Remove a depreciation rack.

Unscrew 2 screws 5 of a basic pipe of a depreciation rack on a rotary fist.

Take a depreciation rack from a wheel niche.

Installation

Establish a rack on a dome of a depreciation rack.

Freely twist a nut 1.

NOTE Use a new nut

Establish a basic pipe of a depreciation rack on a rotary fist.

Tighten 2 new screws 3 and a new nut of 80 N · m + 60 ° + 15 °.

Connect a plait of wires of the ABS 2 wheel sensor to the holder's clips on a basic pipe of a depreciation rack.

Mount a pendulum 1 on a basic pipe of a depreciation rack of 65 N · m.

Use a new nut.

Hold two flat surfaces of a spherical finger of the hinge with an open wrench.

Establish a forward wheel of 110 N · to m.

Lower the car on the earth.

Tighten the top nut of 2 55 N · m.

Put on a protective cap 1 the shock-absorber.

Check wheel disorder, if necessary adjust.