Lift and install the car on supports or over a viewing hole.

Install the selector in situation "P".

Wring out a spherical support of a cable of the selector from a switching axis up.

Switch the selector from situation "P" to situation "1". At the same time the drive has to move easily. Otherwise replace a cable.

Switch the selector to situation "P". At the same time blocking of the parking has to be included, forward wheels should not rotate.

In this situation the cable of the selector has to without effort be pressed through on the switching axis lever. Otherwise make adjustment of a cable.

Switch the selector to situation "P".

Press a switching axis at the transmission in extreme back situation. Blocking of the parking has to be recorded.

Turn off a bolt 3 support at the transmission a little. Displace a support so that the cable could be pressed through freely on the switching axis lever. In this situation tighten a bolt the moment of 25 N · m.

Pass on the car and check operation of the selector. The engine can be started only in position of the selector "P" and "N".

Include ignition. On the motionless car the selector has to be brought out of situation "P" or "N" only when the brake pedal is at the same time pressed.