6.4.4. Removal and installation / replacement of the ABS hydrounit (ABS 8.0, ABS 8.0 CCD)
|
ATTENTION
Before repair work on the ABS hydrounit or the control unit for the ABS hydrounit it is necessary to read the instruction for repair.
|
Removal
2 take away consolidation for a tank of a radiator as it is possible further.
1 for the main brake cylinder cast away a protective cover up.
Install KM-558-10 device on a tank for brake fluid.
Unscrew a carving cover 1.
Pour brake fluid to edge.
Screw up by means of KM-558-10.
|
NOTE
Collect the spilled brake fluid.
|
Weaken brake tubes 2 on the main brake cylinder.
Weaken 2 nuts.
Dismantle a guide for a brake tube 3 from the face panel.
Dismantle the ABS hydrounit.
Dismantle all brake tubes from the hydrounit.
Turn off 6 nuts (arrow).
|
NOTE
Use a pipe key. To pay attention to compliance of a brake tube.
|
Insert the socket of a plait of wires 1.
Turn off 2 nuts 2.
Unscrew the hydrounit in the face panel through the holder.
Installation
Mount the ABS hydrounit.
Unscrew the hydrounit in the holder.
Put 2 clamps of 2 10 N · m.
Insert the socket of a plait of wires 1.
Mount all brake tubes in the hydrounit.
Put 6 clamps (shooter) of 16 N · m.
|
NOTE
Use a pipe key. To pay attention to compliance of a brake tube.
|
Mount brake tubes 2 on the main brake cylinder.
Put 2 clamps of 16 N · m.
Mount a guide for brake tubes 3 on the face panel.
Remove air from the brake system and check tightness.
1 for the main brake cylinder cast away a protective cover up.
Mount consolidation on a tank of a radiator 2.
When replacing the control unit: program the ABS control unit.