2.4.1. Removal and installation of the case of an oil filter (Z10XE, Z10XEP, without conditioner)
NOTE
On cars since a year of release 04 with ESP – after each detachment of the accumulator the sensor of an angle of rotation of a steering wheel loses the main installation. It needs to be calibrated anew.
|
Lubricant contour
* The engine is heated-up and idles
Lubricant contour
* The engine is heated-up and idles
Removal
Open a cowl.
Disconnect plugs of the rechargeable battery.
Disconnect a weight wire.
Dismantle heated a lambda sensor of regulation of composition of fuel mix.
Disconnect the socket of a plait of wires.
Release a plait of wires.
Carefully turn out by means of KM-61291 adaptation.
Dismantle a transport earring of the engine 2 at the left.
Turn out a bolt.
Dismantle a guard of a final collector.
Turn off 3 bolts of fastening.
Turn the directing tube of the probe of an oil meter forward.
Uncover the case of an oil filter.
NOTE
On option of the ECO model uncover motor office below.
|
Substitute the reception pallet.
Remove the case of an oil filter.
Turn off 3 bolts of fastening (arrow).
Clean the sealing surfaces of the case of an oil filter, the block of cylinders.
Installation
Install the case of an oil filter.
Replace consolidation.
Tighten bolts the moment of an inhaling of 20 N · m.
Establish a cover of the case of an oil filter.
Replace a sealing ring.
Tighten bolts of fastening of a cover the moment of 10 N · m.
Establish a guard of a final collector.
Establish the directing oil meter probe tube.
Tighten 3 bolts of fastening the moment of 8 N · m.
Establish a transport earring of the engine at the left.
Establish heated a lambda sensor of regulation of composition of fuel mix.
Apply on a carving assembly paste (white).
Tighten a lambda sensor the moment 40 N · m.
Attach the socket of a plait of wires.
Fix a plait of wires.
On option of the ECO model establish a cover of motor office below.
Connect plugs of the rechargeable battery.
Program volatile memory.
Close a cowl.